When should the screen and blade of the copper cable recycling machine be replaced?

In the processing process of copper cable recycling machine itself is a certain loss, screen and blade as consumption is more obvious, so when can the screen and blade of copper cable recycling machine be replaced? Copper cable recycling machine mesh and screen pieces inside the machine, we cannot directly observe small abrasion of copper cable recycling machine consumables, but from the processing of copper cable recycling machine and plastic separation degree of reasoned that if the copper and plastic separation of copper cable recycling machine suddenly appeared not clean, some copper wire are all broken, It is necessary to check whether the screen and copper plastic sorting of the copper cable recycling machine need to be replaced. In general, the blade wear of the copper cable recovery machine is manifested as the copper wire is not completely broken, and the damage or blockage of the screen will lead to not all or no sorting.

When the edge is worn for obtuse Angle, it is necessary to use automatic knife grinder or grinder to grind the edge out. If the grinding times are many and the distance between the turning knife and the fixed knife is too large, it is necessary to replace the copper grinding knife. Vibration sorting plays an important role in the sorting system of small copper cable recycling machine. The sorting screen will appear wear, breakdown, blockage and other problems when used for a long time, which affects the normal processing of small copper cable recycling machine and reduces our earnings per unit time. When replacing, we only need to remove the upper cover of the sorting part, and we can see the screen, and complete the replacement of the screen of the copper cable recycling machine.