The principle of wire and cable crushing recovery equipment

First configure automatic feeding machine can replace artificial feeding, support for automatic feeding device, save a lot of manpower and time, through the conveyor on the machine feeding material into the crusher (shear machine) cable, cable can control by means of shear screen mesh size to adjust length of material shear after the material, at the same time by means of shear to shear separation, the copper and lineThen through screw conveyor set (conveyor) to specific gravity separation facilities, specific gravity separation facilities are up to the introduction of German technology to independent research and development on technology of environmental protection of gravity separation facilities, the principle of vibration by wind pressure, the use of copper and plastic separation, the proportion of differences of specific gravity separation facilities out in front of the discharging mouth for copper material, after the rear discharge for lightweight plastic material.

Among them, because of the complex material of waste wire and cable, it not only contains copper and plastic, but also other impurities like soil and other impurities. If it is not treated, it will have a certain impact on the production environment and human health. The traceable waste copper cable recycling machine and equipment drive the dust and impurities to the bag dust removal facility through the wind pressure of the induced draft fan.The material adsorption of the induced draft fan is transported by welding of two pipes above the specific gravity sorting equipment. The dust transported to the cloth bag dust removal facility can be collected to achieve a harmless and environmentally friendly separation process.In addition, the whole machine copper cable recovery machine (waste wire and cable crushing recovery equipment) is controlled by the distribution cabinet, operating on the same platform, which is very simple, fast and convenient