Dry copper cable recovery machine prone to problems

1, if the copper cable recovery machine is not debugged in place before the production, the separation of the equipment will be a problem.Copper cable recycling machine equipment produced before equipment installation and debugging is very important, including the detection of copper cable recycling machine load test, test to the standard work experience at the empty on the basis of determination of copper cable recycling machine LiaoDu from practice, and production is in accordance with the requirements, and copper cable recycling machine equipment shall run smoothly at work, should not have a violent oscillation, if there is any difference,Turn off the equipment immediately and check whether the fasteners are firm.

2. The air volume and oscillation frequency of the copper cable recovery machine do not match, and this phenomenon will also occur.The air volume of the copper cable recovery machine is too large or too small and the oscillation frequency does not match, which will seriously affect the copper and plastic separation rate of the copper host, and then affect the working efficiency of the copper cable recovery machine.

3, the diameter of the waste wire is fine, the water type copper cable recycling machine can process a variety of diameter between 2-20mm of the electrical line, miscellany line, communication line, data line, headphone line and other waste wire.If the diameter of the waste wire is too fine, the working efficiency of the dry copper cable recovery machine will be affected, and the separation will decline. At this time, it is necessary to choose the water type shaking table to support the operation.Or add the recycling wet copper cable recovery machine to separate the crushing and sorting of such wires.